

























ある特定の情景をレイアウトに再現するといういわゆる「ジオラマ」ではなく、「模型車両が走行可能な造形作品」として制作したもの。 2007年に、「鉄道模型」の工作としては初めて制作したものです。 制作開始した2007年当時は2分割のモジュールでしたが、完成直前に中断しそのまま放置、7年後の2014年に真中のモジュールを1つ追加して3分割とし、全体の塗装も変更して一応完成としました。
画像では、2007年に制作したモジュールを「01」「02」、2014年に新しく追加したモジュールを「03」としています。将来また新しいモジュールの追加も可能ですが、2014年現在のところ未定です。
Rather than a conventional “diorama,” which recreates a specific scene in a layout, this work was created as a sculptural work in which model railway vehicles can actually run. It was the first work I made as a railway modeling project, begun in 2007.
When work began in 2007, it consisted of two modules. The project was left unfinished shortly before completion and remained untouched for seven years. In 2014, I added a new module between the original two, making it a three-module layout, and changed the overall color scheme. This brought the work to a provisional completion.
In the images, the modules made in 2007 are labeled “01” and “02,” while the module newly added in 2014 is labeled “03.” Additional modules could be added in the future, although no plans had been made as of 2014.
主な使用材料:
- 工作用のヒノキ角材・シナベニア(台座部分)
- 水性ステイン(ターナー WoodStain、販売終了品)
- 銅線・照明用LED
- 2014年の改修当時、3mm砲弾型LEDには560オーム抵抗のみ、CRDなし
- LED+560オーム抵抗を1組とし、全20〜30組程度を全て並列接続
- 鉄道模型用レール「PECO コード100/16.5mm」
- 「01」「02」モジュールでは、L=900mmを各2本程度づつ、「03」モジュールでは4本弱使用)
3つのモジュールで、レールの総延長は6〜7m程度。 - 篠原製の犬釘で固定(販売終了品)
- その他
- 「01」「02」モジュールでは、L=900mmを各2本程度づつ、「03」モジュールでは4本弱使用)
- スケールは1:50 程度を想定
大きさ:
- 各ブロック共に、H=300〜400mm程度 × W 600mm × D 290mm、
3つのモジュールをつなげると、長さは1.8m程度。
車両:
- 2007年に購入した無改造の「BACHMANN On30 S281X(ガスメカニカル・ダベンポート 0-4-0 )」。 2007年に作ったモジュール「2」の螺旋部分のレールがかなり急カーブ、かつ天井高さが低めなので、2軸のホイールベースが約24mmで、車格が小振りでオーバーハングが少ないこの車両しか走行できないみたいです。 この車両はモーターのパワーが強く、全体の重さもちょうど良い感じで、きちんと走行します。
(ホイールベースが32mm程度の車両だと急カーブで脱線が多くなり走行不可)
Main materials:
- Hinoki cypress square timber and shina plywood (for the base)
- Water-based wood stain (Turner WoodStain, discontinued)
- Copper wire and LEDs for lighting
- At the time of the 2014 renovation, the 3 mm round LEDs were used with 560-ohm resistors only, without CRDs.
- Each set consisted of one LED and one 560-ohm resistor, with approximately 20–30 sets connected entirely in parallel.
- model railway track: “PECO Code 100 / 16.5 mm”
- Approximately two 900 mm lengths were used for each of the “01” and “02” modules, and just under four lengths for the “03” module.
The three modules have a total track length of approximately 6–7 m (236.2〜275.6 in). - The track is secured with Shinahara track spikes.(discontinued)
- Other materials, etc.
- Approximately two 900 mm lengths were used for each of the “01” and “02” modules, and just under four lengths for the “03” module.
- The intended scale is approximately 1:50.
Dimensions:
- Each module: approximately H=300〜400mm × W 600mm × D 290 mm、approximately H 11.8–15.7 × W 23.6 × D 11.4 in.
- When the three modules are connected, the overall length is approximately 1.8 m(70.9 in).
Rolling stock:
- An unmodified “BACHMANN On30 S281X (Gas Mechanical Davenport 0-4-0),” purchased in 2007. The track in the spiral section of module “02,” made in 2007, has very tight curves and relatively low overhead clearance. As a result, this appears to be the only vehicle that can run on the layout, as it has a short wheelbase of approximately 24 mm and a relatively compact body with little overhang.The motor has ample power, and the vehicle’s overall weight seems to be well suited to the layout, allowing it to run reliably. Vehicles with a wheelbase of around 32 mm tend to derail frequently on the tight curves and cannot be operated.

a008 極小 小判形軌道 #1|Minimum Oval Truck #1 2016
Production and photography by Yamao Hiroshi, 2016
(OLYMPUS E-620 + ZUIKO 9-18mm/14-42 mm)
20186年(平成28年)発表
Announced on 2016
2026年(令和8年)10月7日移転掲載
Published on October 7, 2026, following the site relocation.


Contents


















